Removal [08/2019 - ]: Procedure

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2019 - 08/2022] , or refer to INITIALIZATION [08/2022 - ] ).
REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 1
REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 2
REMOVE HEATER CONTROL ASSEMBLY
Refer to PROCEDURE - Step 3
REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKETS
- For Radio and Display Type:
  Refer to PROCEDURE - Step 4
- For Navigation Receiver Type:
  Refer to PROCEDURE - Step 5

REMOVE ACCESSORY METER ASSEMBLY

Remove the 2 screws.

Disconnect the connector to remove the accessory meter assembly as shown in the illustration.