Installation [02/2014 - 11/2016]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Refer to INITIALIZATION [02/2014 - 11/2016]
1. Install a new gasket to the engine coolant temperature sensor.
2. Using a 19 mm union nut wrench, install the engine coolant temperature sensor to the water outlet.
  Torque: 19.6 N*m (200 kgf*cm, 14 ft.*lbf)
  NOTE:
  - If the engine coolant temperature sensor has been struck or dropped, replace it.
  - Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench.
    Refer to PRECAUTION [02/2014 - 11/2016]
3. Connect the engine coolant temperature sensor connector.
INSTALL AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
See step 3
INSTALL INLET NO. 1 AIR CLEANER
See step 4
INSTALL INLET NO. 2 AIR CLEANER
See step 5
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 4
INSTALL RADIATOR SIDE SEAL RH
Refer to PROCEDURE - Step 5
INSTALL RADIATOR SIDE DEFLECTOR SEAL LH
Refer to PROCEDURE - Step 6
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 68 , or refer to PROCEDURE - Step 67
INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 10 , or refer to PROCEDURE - Step 10
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
Refer to INSTALLATION [02/2014 - ]
ADD ENGINE COOLANT
Refer to PROCEDURE - Step 3
INSPECT FOR COOLANT LEAK (for Engine)
Refer to PROCEDURE - Step 1
PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
  Refer to INITIALIZATION [02/2014 - 11/2016]