Disassembly [02/2014 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE NO. 1 HEATER TO REGISTER DUCT
- Remove the 3 screws <D> and No. 1 heater to register duct.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
- Remove the screw <D>.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disengage the 2 claws and remove the No. 1 side defroster nozzle duct.
- REMOVE NO. 4 HEATER TO REGISTER DUCT
- Remove the 3 screws <D> and No. 4 heater to register duct.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
- Remove the screw <D>.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disengage the 2 claws and remove the No. 2 side defroster nozzle duct.
- REMOVE DEFROSTER NOZZLE ASSEMBLY
- Remove the 3 screws <D> and defroster nozzle assembly.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
Refer to PROCEDURE - Step 3
- REMOVE ANTENNA CORD SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
- REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 6
- REMOVE CENTER HEATER TO REGISTER SUB DUCT
- Remove the 2 screws <D> and center heater to register sub duct.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE AUTOMATIC LIGHT CONTROL SENSOR
Refer to PROCEDURE - Step 7
- REMOVE NO. 4 INSTRUMENT PANEL WIRE
- Disengage the 12 clamps to remove the No. 4 instrument panel wire.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 INSTRUMENT PANEL SPACER
- Remove the No. 1 instrument panel spacer.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 2 INSTRUMENT PANEL SPACER
- Remove the No. 2 instrument panel spacer.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 4 INSTRUMENT PANEL CUSHION
- Remove the No. 4 instrument panel cushion.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 3 INSTRUMENT PANEL CUSHION
- Remove the 4 No. 3 instrument panel cushions.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 DEFROSTER NOZZLE GARNISH
- Disengage the 4 claws, 2 clips and 4 guides to remove the No. 1 defroster nozzle garnish.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE INSTRUMENT PANEL CUSHION
- Remove the instrument panel cushion.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 SIDE DEFROSTER NOZZLE
- Disengage the 2 claws to remove the No. 1 side defroster nozzle.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 2 SIDE DEFROSTER NOZZLE
- Disengage the 2 claws to remove the No. 2 side defroster nozzle.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 INSTRUMENT PANEL PIN
- Remove the 2 screws <D> and 2 No. 1 instrument panel pins.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|