LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 59 (Lighting System (Exterior) - Service Information - (Hybrid)) >> Automatic Light Control Sensor >> Removal [02/2014 - ] >> Procedure

Removal [02/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY 

    Refer to REMOVAL [02/2014 - ]

  2. REMOVE NO. 1 HEATER TO REGISTER DUCT 

    Refer to PROCEDURE - Step 1

  3. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT 

    Refer to PROCEDURE - Step 2

  4. REMOVE NO. 4 HEATER TO REGISTER DUCT 

    Refer to PROCEDURE - Step 3

  5. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT 

    Refer to PROCEDURE - Step 4

  6. REMOVE DEFROSTER NOZZLE ASSEMBLY 

    Refer to PROCEDURE - Step 5

  7. REMOVE AUTOMATIC LIGHT CONTROL SENSOR 
    1. Disconnect the connector.
      GTY455952Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, disengage the 2 claws to remove the automatic light control sensor.
      GTY449437Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals