LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 70 (Supplemental Restraint System (Service Information) (Hybrid)) >> Front Passenger Airbag Assembly >> Removal [02/2014 - ] >> Procedure

Removal [02/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    Refer to PRECAUTION [02/2014 - 11/2016] , or refer to PRECAUTION [11/2016 - ]

    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [02/2014 - 11/2016] , or refer to PRECAUTION [11/2016 - ]

  2. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL 

    Refer to REMOVAL [02/2014 - ]

  3. DISCONNECT NO. 2 INSTRUMENT PANEL WIRE 
    1. Check that the power switch is off.
    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
      WARNING:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Slide the slider to release the lock, and then disconnect the connector.
      GTY439831Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Slider
      NOTE:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  4. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 49

  5. REMOVE NO. 4 HEATER TO REGISTER DUCT 

    Refer to PROCEDURE - Step 3

  6. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY 
    WARNING:

    When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.

    1. Remove the 2 screws.
      GTY452872Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Lean the instrument panel safety pad sub-assembly and disengage the 3 hooks.
      GTY435151Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the instrument panel safety pad sub-assembly.
      GTY435150Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE NO. 2 INSTRUMENT PANEL WIRE 
    1. Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locks.
      GTY426955Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Airbag Connector
      *c Airbag Connector Lock
    2. Disconnect the 2 airbag connectors to remove the No. 2 instrument panel wire from the instrument panel passenger airbag assembly.
      NOTE:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

scientia non olet · About LEMON Manuals