LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 100 (Combination Meter / Clock (Service Information) (Hybrid)) >> Clock >> Installation [02/2014 - ] >> Procedure

Installation [02/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL CLOCK ASSEMBLY 
    1. Connect the connector.
    2. Engage the 2 claws.
    3. Install the clock assembly with the 2 screws.
  2. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type) 

    Refer to PROCEDURE - Step 5

  3. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type) 

    Refer to PROCEDURE - Step 5

  4. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 25

  5. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 26

  6. INSTALL CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 27

  7. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL WITH AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 28

  8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [02/2014 - 11/2016] Refer to INITIALIZATION [11/2016 - ]

  9. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 71 Refer to PROCEDURE - Step 72 Refer to PROCEDURE - Step 70

  10. INSTALL DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 72 Refer to PROCEDURE - Step 73 Refer to PROCEDURE - Step 71

scientia non olet · About LEMON Manuals