LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 52 (Audio / Video System (Service Information) (Hybrid)) >> Radio Receiver >> Installation [02/2014 - ] >> Procedure

Installation [02/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY 
  2. INSTALL NO. 1 RADIO RECEIVER BRACKET 
    1. Install the No. 1 radio receiver bracket with the 3 screws.
  3. INSTALL NO. 2 RADIO RECEIVER BRACKET 
    1. Install the No. 2 radio receiver bracket with the 3 screws.
  4. INSTALL STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio) 

    See step  3

  5. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET 
    1. Connect each connector.
    2. Engage the 2 claws and 2 clips to temporarily install the radio receiver assembly with bracket.
    3. Install the radio receiver assembly with bracket with the 4 bolts.
  6. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 25

  7. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 26

  8. INSTALL CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 27

  9. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL WITH AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 28

scientia non olet · About LEMON Manuals