LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2015 >> Avalon Hybrid Limited >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System (Service Information) (Hybrid) >> Navigation Receiver >> Removal [10/2014 - ] >> Procedure

Removal [10/2014 - ]: Procedure

  1. PRECAUTION 

    (Refer to PRECAUTION [10/2014 - 10/2015] or PRECAUTION [10/2015 - ] )

    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Refer to PRECAUTION [10/2014 - ] ).

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER 

    Refer to PROCEDURE - Step 2

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [10/2014 - 10/2015] or INITIALIZATION [10/2015 - ] ).

  4. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 1 and PROCEDURE - Step 1

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 5

  6. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY 
    1. Remove the 4 bolts.
      GTY475228Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector.
      GTY475229Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 4 clips.
    4. Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.
  7. REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 4

  8. REMOVE NO. 1 RADIO RECEIVER BRACKET 

    Refer to PROCEDURE - Step 5

  9. REMOVE NO. 2 RADIO RECEIVER BRACKET 

    Refer to PROCEDURE - Step 6

  10. REMOVE AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 11

  11. REMOVE NO. 1 NAVIGATION WIRE (w/ Satellite Radio) 

    Refer to PROCEDURE - Step 12

  12. REMOVE STEREO COMPONENT TUNER ASSEMBLY (w/ Satellite Radio) 
  13. REMOVE NAVIGATION ECU SUB-ASSEMBLY