Removal [10/2014 - ]: Procedure
- PRECAUTION (for Navigation Receiver Type) NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work. (Refer to PRECAUTION [10/2014 - ] )
- REMOVE LUGGAGE TRIM SERVICE HOLE COVER (for Navigation Receiver Type)
Refer to PROCEDURE - Step 2
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (for Navigation Receiver Type) NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (Refer to INITIALIZATION [10/2014 - 10/2015] or INITIALIZATION [10/2015 - ] )
- REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 1 or PROCEDURE - Step 1
- REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 5
- REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Radio and Display Type)
See step 3
- REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Navigation Receiver Type)
Refer to PROCEDURE - Step 6
- REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL
See step 4
- REMOVE NO. 1 RADIO RECEIVER BRACKET
See step 5
- REMOVE NO. 2 RADIO RECEIVER BRACKET
See step 6
- REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Refer to PROCEDURE - Step 11
- REMOVE NO. 1 NAVIGATION WIRE
- REMOVE STEREO COMPONENT TUNER ASSEMBLY