Removal [12/2012 - 08/2016]: Procedure

See step  1

Refer to REMOVAL [12/2012 - 10/2015] , or refer to REMOVAL [10/2015 - ]

Refer to PROCEDURE - Step 12 [12/2012 - 10/2015] , or refer to PROCEDURE - Step 15 [10/2015 - 08/2016]

Refer to PROCEDURE - Step 9 [12/2012 - 10/2015] , or refer to PROCEDURE - Step 9 [10/2015 - 08/2017]

1. Remove the bolt and disconnect the discharge hose sub-assembly from the cooler condenser assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the O-ring from the discharge hose sub-assembly.
   NOTE:

   Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

1. Remove the bolt and disconnect the liquid pipe sub-assembly from the cooler condenser assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the O-ring from the liquid pipe sub-assembly.
   NOTE:

   Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

Refer to PROCEDURE - Step 13 [12/2012 - 10/2015] , or refer to PROCEDURE - Step 13 [10/2015 - 08/2017]

1. Detach the 3 clamps and disconnect the water by-pass pipe from the No. 2 fan shroud.
2. Remove the 2 bolts and No. 2 fan shroud.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Detach the 2 guides and remove the cooler condenser assembly as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Do not damage the cooler condenser or radiator when removing the cooler condenser assembly.