LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Restraints >> Passive Restraints >> Seat Belt (Except Hybrid) >> Rear No. 1 Seat Outer Belt Assembly >> Installation

Rear No. 1 Seat Outer Belt Assembly: Installation

  1. INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY 
    1. Install the rear No. 1 seat outer belt assembly with the 2 bolts.

      Torque: Bolt < A > 

      7.5 N*m (77 kgf*cm, 66 in.*lbf) 

      Bolt < B > 

      42 N*m (428 kgf*cm, 31 ft.*lbf) 

      Fig 1: Identifying Rear No. 1 Seat Outer Belt Assembly With Bolts
      G05419462Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the shoulder anchor of the rear No. 1 seat outer belt assembly with the bolt.

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

    3. Check if the ELR locks.
      NOTE: The check should be performed with outer belt assembly installed.
      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.
        Fig 2: Identifying Shoulder Anchor Of Rear No. 1 Seat Outer Belt Assembly
        G05419460Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL QUARTER PILLAR GARNISH  (See INSTALLATION )
  3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)  (See INSTALLATION )
  4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)  (See INSTALLATION )
  5. CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY 
    1. Connect the floor anchor end of the rear No. 1 seat outer belt assembly and install the bolt.

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

      NOTE: Do not allow the anchor part of the rear No. 1 seat outer belt assembly to overlap the protruding part of the floor panel.
      Fig 3: Identifying Floor Anchor End Of Rear No. 1 Seat Outer Belt Assembly With Bolt
      G05419464Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL FRONT DECK SIDE TRIM COVER  (See INSTALLATION )
  7. INSTALL NO. 2 DECK SIDE TRIM HOOK (for LH Side)  (See INSTALLATION )
  8. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for RH Side)  (See INSTALLATION )
  9. INSTALL ROPE HOOK ASSEMBLY  (See INSTALLATION )
  10. INSTALL REAR DECK TRIM COVER (for LH Side without Remote Folding Function)  (See INSTALLATION )
  11. INSTALL RECLINING REMOTE CONTROL LEVER BEZEL LH (for LH Side with Remote Folding Function)  (See INSTALLATION )
  12. INSTALL REAR POWER OUTLET SOCKET COVER (for LH Side)  (See INSTALLATION )
  13. INSTALL REAR POWER POINT SOCKET ASSEMBLY (for LH Side)  (See INSTALLATION )
  14. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH (for LH Side)  (See INSTALLATION )
  15. INSTALL REAR COMBINATION LIGHT SERVICE COVER RH (for RH Side)  (See INSTALLATION )
  16. INSTALL SIDE TRIM COVER RH (for RH Side without Rear Automatic Air Conditioning System)  (See INSTALLATION )
  17. INSTALL REAR ROOM TEMPERATURE SENSOR (for RH Side with Rear Automatic Air Conditioning System)  (See INSPECTION )
  18. INSTALL SIDE TRIM COVER LH (for LH Side without Rear Seat Entertainment System)  (See INSTALLATION )
  19. INSTALL POWER OUTLET SOCKET BEZEL (for LH Side with Rear Seat Entertainment System)  (See INSTALLATION )
  20. INSTALL DECK SIDE TRIM  (See INSTALLATION )
  21. INSTALL DECK SIDE TRIM COVER  (See INSTALLATION )
  22. INSTALL REAR SEAT SIDE GARNISH CAP (for RH Side without Rear Air Conditioning System)  (See INSTALLATION )
  23. INSTALL REAR SEAT SIDE GARNISH CAP (for RH Side with Rear Air Conditioning System)  (See INSTALLATION )
  24. INSTALL REAR FLOOR FINISH PLATE  (See INSTALLATION )
  25. INSTALL REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)  (See INSTALLATION )
  26. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY LH (w/ Rear No. 2 Seat)  (See INSTALLATION  )
  27. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY RH (w/ Rear No. 2 Seat) 
  28. INSTALL REAR NO. 2 SEAT INNER BELT ASSEMBLY (w/ Rear No. 2 Seat)  (See INSTALLATION  )
  29. INSTALL REAR DECK FLOOR BOX (w/o Rear No. 2 Seat)  (See INSTALLATION )
  30. INSTALL DECK FLOOR BOARD ASSEMBLY (w/ Rear No. 2 Seat)  (See INSTALLATION )
  31. INSTALL REAR MAT  (See INSTALLATION )
  32. INSTALL DECK FLOOR BOARD ASSEMBLY (w/o Rear No. 2 Seat)  (See INSTALLATION )
  33. INSTALL DECK SIDE TRIM BOX LH  (See INSTALLATION )
  34. INSTALL REAR SEAT SIDE COVER LH (w/ Rear No. 2 Seat)  (See INSTALLATION )
  35. INSTALL REAR NO. 1 FLOOR BOARD (w/o Rear No. 2 Seat)  (See INSTALLATION )
  36. INSTALL DECK SIDE TRIM BOX RH  (See INSTALLATION )
  37. INSTALL JACK CARRIER ASSEMBLY  (See INSTALLATION )
  38. INSTALL JACK ASSEMBLY  (See INSTALLATION )
  39. INSTALL JACK CARRIER CUSHION  (See INSTALLATION )
  40. INSTALL JACK CARRIER SUPPORT 
  41. INSTALL REAR SEAT SIDE COVER RH (w/ Rear No. 2 Seat)  (See INSTALLATION )
  42. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 
  43. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  44. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  45. INSTALL DECK BOARD ASSEMBLY  (See INSTALLATION )
  46. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 
  47. INSTALL REAR DOOR SCUFF PLATE  (See INSTALLATION )
  48. INSTALL REAR NO. 1 SEAT ASSEMBLY  (See INSTALLATION )
  49. CONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY (w/ Remote Folding Function)  (See INSTALLATION )
  50. INSPECT REAR SEAT SLIDE ADJUSTER LOCK  (See INSTALLATION )
  51. INSTALL REAR SEAT LEG SIDE COVER  (See INSTALLATION )
  52. INSTALL REAR INNER TRACK BRACKET COVER  (See INSTALLATION )
  53. INSTALL REAR OUTER TRACK BRACKET COVER  (See INSTALLATION )
  54. INSTALL REAR SEAT TRACK BRACKET COVER  (See INSTALLATION )
  55. INSTALL REAR SEAT HEADREST ASSEMBLY  (See INSTALLATION )
  56. INSTALL REAR CENTER SEAT ASSEMBLY (for LH Side) 
scientia non olet · About LEMON Manuals