LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat (Except Hybrid) >> Rear No. 2 Seat Assembly >> Installation

Rear No. 2 Seat Assembly: Installation

  1. INSTALL REAR NO. 2 SEAT ASSEMBLY 
    1. Install the rear No. 2 seat assembly with the 4 bolts.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

  2. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY RH  (See INSTALLATION )
  3. CONNECT REAR SEAT LAP TYPE BELT ASSEMBLY LH  (See INSTALLATION )
    Fig 1: Identifying Rear No. 2 Seat Assembly And Bolts
    G06113736Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL REAR NO. 2 SEAT INNER BELT ASSEMBLY  (See INSTALLATION )
  5. INSTALL DECK FLOOR BOARD ASSEMBLY  (See INSTALLATION )
  6. INSTALL REAR MAT  (See INSTALLATION )
  7. INSTALL DECK SIDE TRIM BOX RH  (See INSTALLATION )
  8. INSTALL JACK CARRIER ASSEMBLY  (See INSTALLATION )
  9. INSTALL JACK ASSEMBLY  (See INSTALLATION )
  10. INSTALL JACK CARRIER CUSHION  (See INSTALLATION )
  11. INSTALL JACK CARRIER SUPPORT 
  12. INSTALL REAR SEAT SIDE COVER RH  (See INSTALLATION )
  13. INSTALL DECK SIDE TRIM BOX LH  (See INSTALLATION )
  14. INSTALL REAR SEAT SIDE COVER LH  (See INSTALLATION )
  15. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 
  16. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  17. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  18. INSTALL DECK BOARD ASSEMBLY  (See INSTALLATION )
scientia non olet · About LEMON Manuals