LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> Restraints >> Passive Restraints >> Seat Belt (Except Hybrid) >> Rear No. 2 Seat Inner Belt Assembly >> Installation

Rear No. 2 Seat Inner Belt Assembly: Installation

  1. INSTALL REAR NO. 2 SEAT INNER BELT ASSEMBLY 
    1. Install the rear No. 2 seat inner belt assembly with the bolt.

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

      NOTE: Do not allow the anchor part of the rear No. 2 seat inner belt assembly to overlap the protruding part of the rear No. 2 seat bracket.

      HINT:

      Use the same procedure for the RH side and LH side.

  2. INSTALL REAR MAT  (See INSTALLATION )
  3. INSTALL DECK FLOOR BOARD ASSEMBLY  (See INSTALLATION )
    Fig 1: Identifying Rear No. 2 Seat Inner Belt Assembly Bolt
    G05419449Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL DECK SIDE TRIM BOX LH  (See INSTALLATION )
  5. INSTALL REAR SEAT SIDE COVER LH  (See INSTALLATION )
  6. INSTALL DECK SIDE TRIM BOX RH  (See INSTALLATION )
  7. INSTALL JACK CARRIER ASSEMBLY  (See INSTALLATION )
  8. INSTALL JACK ASSEMBLY  (See INSTALLATION )
  9. INSTALL JACK CARRIER CUSHION  (See INSTALLATION )
  10. INSTALL JACK CARRIER SUPPORT 
  11. INSTALL REAR SEAT SIDE COVER RH  (See INSTALLATION )
  12. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 
  13. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  14. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  15. INSTALL DECK BOARD ASSEMBLY  (See INSTALLATION )
scientia non olet · About LEMON Manuals