LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Emission Control System (1AR-FE)) >> Purge Valve >> Removal

Purge Valve: Removal

WARNING: This page is about a different variant/trim than selected.
  1. SEPARATE EJECTOR TUBE  (See REMOVAL )
  2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See REMOVAL )
  3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See REMOVAL )
  4. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See REMOVAL )
  6. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE NO. 1 VACUUM SWITCHING VALVE 
    1. Disconnect the No. 1 vacuum switching valve connector.
    2. Disconnect the wire harness clamp.
    3. Disconnect the 2 fuel vapor feed hoses from the No. 1 vacuum switching valve.
    4. Remove the No. 1 vacuum switching valve from the air cleaner hose.
    Fig 1: Locating No. 1 Vacuum Switching Valve Connector And Fuel Vapor Feed Hoses
    G06115096Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals