LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Intake (1AR-FE)) >> VACUUM SWITCHING VALVE (for ACIS) >> Removal

VACUUM SWITCHING VALVE (for ACIS): Removal

WARNING: This page is about a different variant/trim than selected.
  1. SEPARATE EJECTOR TUBE  (See REMOVAL )
  2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See REMOVAL )
  3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See REMOVAL )
  4. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See REMOVAL )
  6. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  (See REMOVAL )
  8. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS) 
    1. Disconnect the 2 vacuum hoses, 2 union to connector tube hoses, clamp and connector.
    2. Remove the bolt and vacuum switching valve assembly (for ACIS).
    Fig 1: Locating Bolt And Vacuum Switching Valve Assembly
    G06115196Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals