FRONT DRIVE SHAFT (for 1AR-FE): Installation

INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
1. Align the shaft splines and install the drive shaft assembly LH with a brass bar and a hammer.
NOTE:
- Set the shaft snap ring with the opening facing down.
- Be careful not to damage the drive shaft dust cover, boot, or oil seal.
- Move the drive shaft assembly while keeping it level.
Fig 1: Installing Drive Shaft Assembly LH With Brass Bar And Hammer
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
1. Install the front drive shaft assembly RH.
2. Install a new bearing bracket hole snap ring and bolt.
  Torque: 32 N*m (330 kgf*cm, 24 ft.*lbf)
NOTE:
- Do not damage the boot or oil seal.
- Move the drive shaft assembly while keeping it level.
INSTALL FRONT AXLE ASSEMBLY LH (See INSTALLATION )
INSTALL NO. 1 FRONT SUSPENSION LOWER ARM LH (See INSTALLATION )
INSTALL TIE ROD ASSEMBLY LH (See INSTALLATION )

Fig 2: Locating Bearing Bracket Hole Snap Ring
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT SPEED SENSOR LH (See INSTALLATION )
INSTALL FRONT STABILIZER LINK ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT AXLE HUB NUT LH
1. Clean the threaded parts on the drive shaft and axle hub nut using a non-residue solvent.
  HINT:
  - Be sure to perform this work for a new drive shaft.
  - Keep the threaded parts free of oil and foreign objects.
2. Using a socket wrench (30 mm), install a new axle hub nut.
  Torque: 294 N*m (2996 kgf*cm, 216 ft.*lbf)
3. Using a chisel and hammer, stake the front axle hub nut.
INSTALL FRONT WHEELS
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
ADD AUTOMATIC TRANSAXLE FLUID
HINT:

(See DISASSEMBLY ).
INSTALL NO. 2 ENGINE UNDER COVER

Fig 3: Staking Front Axle Hub Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 ENGINE UNDER COVER
INSTALL FLOOR UNDER COVER LH
ADJUST FRONT WHEEL ALIGNMENT
HINT:

(See FRONT WHEEL ALIGNMENT ).
CHECK ABS SPEED SENSOR SIGNAL
HINT:

(See TEST MODE PROCEDURE ).