Hood Lock Control Cable Assembly: Removal

REMOVE ENGINE UNDER COVER ASSEMBLY (for 2GR-FE) (See REMOVAL )
REMOVE NO. 1 ENGINE UNDER COVER
REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH (See REMOVAL )
REMOVE FRONT FENDER LINER LH (See REMOVAL )
REMOVE COOL AIR INTAKE DUCT SEAL (See REMOVAL )
REMOVE RADIATOR GRILLE (See REMOVAL )
REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)
1. Remove the hood lock nut cap.
  
  Fig 1: Identifying Hood Lock Nut Cap
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 3 bolts.
  
  Fig 2: Identifying Hood Lock Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the hood lock control cable and remove the hood lock assembly.
  
  Fig 3: Identifying Hood Lock Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)
1. Disconnect the connector.
  
  Fig 4: Locating Hood Lock Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the hood lock nut cap.
  
  Fig 5: Identifying Hood Lock Nut Cap
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 3 bolts.
  
  Fig 6: Identifying Hood Lock Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disconnect the hood lock control cable and remove the hood lock assembly.
Fig 7: Identifying Hood Lock Control Cable
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

Disconnect the hood lock control cable from the hood lock control lever.

Fig 8: Identifying Hood Lock Control Cable And Hood Lock Control Lever
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver, disconnect the clamps shown in the illustration.

Fig 9: Identifying Hood Lock Control Cable, Clamp, Hood Cable Grommet, Wire Harness, Fender Line And Hood Support Rubber

G05422079

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

PART NAME REFERENCE

Area	Part Name	Area	Part Name
A	Hood lock control cable	E	Fender liner
B	Clamp	F	Hood stopper rubber
C	Hood cable grommet	G	Front washer hose
D	Wire harness	H	Rear washer hose

HINT:

Tape the screwdriver tip before use.

Pull the cable from the engine compartment and remove it.