Hood Lock Control Cable Assembly: Installation

INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

Pass the hood lock control cable assembly into the engine compartment.

Fig 1: Identifying Hood Lock Control Cable, Clamp, Hood Cable Grommet, Wire Harness, Fender Line And Hood Support Rubber

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

PART NAME REFERENCE

Area	Part Name	Area	Part Name
A	Hood lock control cable	E	Fender liner
B	Clamp	F	Hood stopper rubber
C	Hood cable grommet	G	Front washer hose
D	Wire harness	H	Rear washer hose

Pass the cable through the upper radiator support.
Connect the clamps as shown in the illustration.
Connect the hood lock control cable to the hood lock control lever.

Fig 2: Identifying Hood Lock Control Cable And Hood Lock Control Lever

INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)
1. Apply MP grease to the sliding areas of the lock.
  
  Fig 3: Locating Grease Applying Area Of Lock
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the hood lock control cable.
  
  Fig 4: Identifying Hood Lock Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the hood lock assembly with the 3 bolts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 5: Identifying Hood Lock Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the hood lock nut cap.
Fig 6: Identifying Hood Lock Nut Cap
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)
1. Apply MP grease to the sliding areas of the lock.
  
  Fig 7: Locating Grease Applying Areas Of Lock
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the hood lock control cable.
  
  Fig 8: Identifying Hood Lock Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the hood lock assembly with the 3 bolts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 9: Identifying Hood Lock Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the hood lock nut cap.
  
  Fig 10: Identifying Hood Lock Nut Cap
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the connector.
INSPECT HOOD SUB-ASSEMBLY (See ON-VEHICLE INSPECTION )
ADJUST HOOD SUB-ASSEMBLY (See REASSEMBLY )
INSTALL RADIATOR GRILLE (See INSTALLATION )

Fig 11: Locating Hood Lock Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
INSTALL FRONT FENDER LINER LH (See INSTALLATION )
INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL NO. 1 ENGINE UNDER COVER
INSTALL ENGINE UNDER COVER ASSEMBLY (for 2GR-FE) (See INSTALLATION )