Tire Pressure Warning Reset Switch: Installation

INSTALL TIRE PRESSURE WARNING RESET SWITCH
1. Engage the 2 claws to install the tire pressure warning reset switch to the driver side knee airbag.
  
  Fig 1: Engaging Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System) (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System) (See INSTALLATION )
INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT TIRE PRESSURE WARNING SYSTEM
HINT:

See TEST MODE PROCEDURE .
INSPECT SRS WARNING LIGHT
HINT:

See DIAGNOSIS SYSTEM .