Driver Side Knee Airbag Assembly: Installation

INSTALL TIRE PRESSURE WARNING RESET SWITCH (See INSTALLATION )
INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
1. Check that the ignition switch is off.
2. Check that the battery negative (-) cable is disconnected.
  CAUTION: Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.
3. Install the DLC3 to the driver side knee airbag assembly with the 2 claws.
  
  Fig 1: Identifying DLC3 With Driver Side Knee Airbag Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the driver side knee airbag connector and tire pressure warning reset switch connector to the driver side knee airbag assembly.
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
  
  Fig 2: Identifying Driver Side Knee Airbag & Tire Pressure Warning Reset Switch Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Support the driver side knee airbag assembly with one hand as shown below.
  
  Fig 3: Supporting Driver Side Knee Airbag Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Temporarily install the driver side knee airbag assembly with the 2 hooks.
  
  Fig 4: Identifying Knee Airbag Assembly Hooks (Driver Side)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Install the driver side knee airbag assembly with the 4 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 5: Identifying Driver Side Knee Airbag Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System) (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System) (See INSTALLATION )
INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT TIRE PRESSURE WARNING SYSTEM
HINT:

(See TEST MODE PROCEDURE )
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).