LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, FWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System (2GR-FE) (Except Hybrid) >> Engine Switch >> Inspection >> Installation

Engine Switch: Inspection: Installation

  1. INSTALL ENGINE SWITCH 
    1. Engage the 2 claws to install the switch.
    2. Connect the switch connector.
      3. Fig 1: Identifying Engine Switch Connector & Claws
      G05415404Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT NO. 1 CONSOLE BOX INSERT  (See INSTALLATION )
  3. INSTALL CONSOLE BOX ASSEMBLY (w/o Rear Air Conditioning System)  (See INSTALLATION )
  4. INSTALL CONSOLE BOX ASSEMBLY (w/ Rear Air Conditioning System)  (See INSTALLATION )
  5. INSTALL LOWER REAR CONSOLE BOX  (See INSTALLATION )
  6. INSTALL NO. 2 CONSOLE BOX DUCT (w/o Rear Air Conditioning System)  (See INSTALLATION )
  7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
  8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System)  (See INSTALLATION )
  9. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)  (See INSTALLATION )
  10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH  (See INSTALLATION )
  11. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  12. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)  (See INSTALLATION )
  13. INSTALL HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System)  (See INSTALLATION )
  14. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Key System)  (See INSTALLATION )
  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
scientia non olet · About LEMON Manuals