Hood Lock Control Cable Assembly: Installation

INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

Pass the hood lock control cable assembly into the engine compartment.

PART NAME TABLE

Area	Part Name
A	Hood lock control cable
B	Clamp
C	Hood cable grommet
D	Wire harness
E	Fender liner
F	Hood stopper rubber
G	Front washer hose
H	Rear washer hose

Fig 1: Identifying Hood Lock Control Cable Assembly

Pass the cable through the upper radiator support.
Connect the clamps as shown below.
Connect the hood lock control cable to the hood lock control lever.

Fig 2: Identifying Hood Lock Control Cable Clamps
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)
1. Apply MP grease to the sliding areas of the lock.
  
  Fig 3: Identifying MP Grease Area
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the hood lock control cable.
  
  Fig 4: Identifying Hood Lock Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the hood lock assembly with the 3 bolts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 5: Identifying Hood Lock Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the hood lock nut cap.
  
  Fig 6: Identifying Hood Lock Nut Cap
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)
1. Apply MP grease to the sliding areas of the lock.
  
  Fig 7: Identifying MP Grease Area
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the hood lock control cable.
  
  Fig 8: Identifying Hood Lock Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the hood lock assembly with the 3 bolts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 9: Identifying Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the hood lock nut cap.
  
  Fig 10: Identifying Hood Lock Nut Cap
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the connector.
  
  Fig 11: Identifying Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT HOOD SUB-ASSEMBLY (See ON-VEHICLE INSPECTION )
ADJUST HOOD SUB-ASSEMBLY (See ADJUSTMENT )
INSTALL RADIATOR GRILLE (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
INSTALL FRONT FENDER LINER LH (See INSTALLATION )
INSTALL FRONT FENDER MOLDING SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL NO. 1 ENGINE UNDER COVER (See INSTALLATION )
INSTALL ENGINE UNDER COVER ASSEMBLY (See INSTALLATION )