How To Proceed With Troubleshooting

HINT:

• The back door closer system troubleshooting procedure based on the premise that the power back door system is operating normally. Check the power back door system first before troubleshooting the back door closer system (See INITIALIZATION  ).
• Use the procedure to troubleshoot the back door closer system.
• *: Use Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use Techstream to check if the CAN communication system is functioning normally.

      Result 

      RESULT TABLE
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

   B:  Go to CAN COMMUNICATION SYSTEM

   A: Go to next step 

4. CHECK FOR DTC* 
   1. Check for DTCs (See DTC CHECK/CLEAR  ).
   2. Clear the DTCs (See DTC CHECK/CLEAR  ).
   3. Recheck for DTCs (See DTC CHECK/CLEAR  ).

      Result 

      RESULT TABLE
      
      

      Result	Proceed to
      DTC is not output	A
      DTC is output	B

   B:  Go to DIAGNOSTIC TROUBLE CODE TABLE 

   A: Go to next step 

5. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT TABLE
   
   

   Result	Proceed to
   Fault is not listed on problem symptoms table	A
   Fault is listed on problem symptoms table	B

   B:  Go to step  7

   A: Go to next step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. See OPERATION CHECK 
   2. See TERMINALS OF ECU 
   3. See DATA LIST/ACTIVE TEST 
7. REPAIR OR REPLACE 
8. CONFIRMATION TEST 

   NEXT: END