Data List/Active Test

HINT:

Using Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

1. Connect Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the tester on.
4. Enter the following menus:

   Select: Body Electrical / Back Door or Main Body / Data List /

5. According to the display on the tester, read the "Data List".

   Back Door (Power back door ECU) 

   DIAGNOSTIC NOTE TABLE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Door Lock Status	Back door lock condition signal / LOCK or UNLOCK	LOCK Back door is locked UNLOCK Back door is unlocked	-
   Closer Position SW	Closer position switch signal / ON or OFF	ON Back door lock center gear is center position OFF Back door lock center gear is not in center position	-
   Courtesy SW	Back door courtesy switch signal / ON or OFF	ON Back door is open OFF Back door is closed	-
   Half Latch SW	Half-latch switch signal / ON or OFF	ON Back door lock motor is open-latch or over-latch OFF Back door lock motor is full-latch or half-latch	-

   Main Body (Main body ECU) 

   DIAGNOSTIC NOTE TABLE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   B Door Handle	Back door open switch signal / ON or OFF	ON- Back door open switch is ON OFF Back door open switch is OFF	-

HINT:

Using Techstream to perform Active Test allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. The Data List can be displayed while performing Active Tests.

1. Connect Techstream to the DLC3.
2. Turn the ignition switch on (IG).
3. Turn the tester on.
4. Enter the following menus:

   Select: Body Electrical / Back Door / Active Test /

5. According to the display on the tester, perform the "Active Test".

   Back Door (Power back door ECU) 

   DIAGNOSTIC NOTE TABLE
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   PBD Motor	Power back door motor	ON / OFF	-
   Latch Release	Power back door motor	ON/OFF	-