LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting (Except Hybrid) >> Automatic Light Control Sensor >> Removal

Automatic Light Control Sensor: Removal

  1. PRECAUTION 

    (See PRECAUTION )

  2. POSITION FRONT WHEELS STRAIGHT AHEAD 
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (See PRECAUTION ).
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  4. REMOVE LOWER NO. 3 STEERING WHEEL COVER  (See REMOVAL )
  5. REMOVE LOWER NO. 2 STEERING WHEEL COVER  (See REMOVAL )
  6. REMOVE STEERING PAD  (See REMOVAL )
  7. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL )
  8. REMOVE STEERING COLUMN COVER  (See REMOVAL )
  9. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY  (See REMOVAL )
  11. REMOVE COMBINATION METER ASSEMBLY  (See REMOVAL )
  12. REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY  (See REMOVAL )
  13. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Smart Key System)  (See REMOVAL )
  14. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Key System)  (See REMOVAL )
  15. REMOVE HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System)  (See REMOVAL )
  16. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)  (See REMOVAL )
  17. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)  (See REMOVAL )
  18. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)  (See REMOVAL )
  19. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  20. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH  (See REMOVAL )
  21. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)  (See REMOVAL )
  22. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System)  (See REMOVAL )
  23. REMOVE FRONT DOOR SCUFF PLATE RH  (See REMOVAL )
  24. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH  (See REMOVAL )
  25. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  26. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY  (See REMOVAL )
  27. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY  (See REMOVAL )
  28. REMOVE NO. 2 CONSOLE BOX DUCT (w/o Rear Air Conditioning System)  (See REMOVAL )
  29. REMOVE LOWER REAR CONSOLE BOX  (See REMOVAL )
  30. REMOVE CONSOLE BOX ASSEMBLY (w/o Rear Air Conditioning System)  (See REMOVAL )
  31. REMOVE CONSOLE BOX ASSEMBLY (w/ Rear Air Conditioning System)  (See REMOVAL )
  32. REMOVE FRONT NO. 1 CONSOLE BOX INSERT  (See REMOVAL )
  33. REMOVE FRONT NO. 2 CONSOLE BOX INSERT  (See REMOVAL )
  34. REMOVE ENGINE SWITCH (w/ Smart Key System)  (See REMOVAL )
  35. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH  (See REMOVAL )
  36. REMOVE FRONT PILLAR GARNISH LH  (See REMOVAL )
  37. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH  (See REMOVAL )
  38. REMOVE FRONT PILLAR GARNISH RH  (See REMOVAL )
  39. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY  (See REMOVAL )
  40. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for LH Side)  (See REMOVAL )
  41. REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY  (See REMOVAL )
  42. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for RH Side)  (See REMOVAL )
  43. DISCONNECT INSTRUMENT PANEL WIRE ASSEMBLY  (See REMOVAL )
  44. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for Pole Antenna Type)  (See REMOVAL )
  45. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for Glass Antenna Type)  (See REMOVAL )
  46. REMOVE NO. 1 HEATER TO REGISTER DUCT  (See DISASSEMBLY )
  47. REMOVE NO. 4 HEATER TO REGISTER DUCT  (See DISASSEMBLY )
  48. REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT  (See DISASSEMBLY )
  49. REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT  (See DISASSEMBLY )
  50. REMOVE DEFROSTER NOZZLE ASSEMBLY  (See DISASSEMBLY )
  51. REMOVE AUTOMATIC LIGHT CONTROL SENSOR 
    1. Disconnect the connector.
    2. Disengage the 2 claws and remove the automatic light control sensor.
      Fig 1: Identifying Automatic Light Control Sensor Claws
      G05419919Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals