Navigation Receiver: Removal

REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY (See REMOVAL )
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Smart Key System) (See REMOVAL )
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Key System) (See REMOVAL )
REMOVE HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System) (See REMOVAL )
REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System) (See REMOVAL )
REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET
1. Remove the 4 bolts.
  
  Fig 1: Identifying Navigation Receiver Assembly Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pull the navigation receiver assembly with bracket toward the rear of the vehicle and disengage the 4 clips.
  
  Fig 2: Identifying Navigation Receiver Assembly Bracket Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect each connector and remove the navigation receiver assembly with bracket.
REMOVE NO. 1 RADIO BRACKET
1. Disengage the claw and disconnect the connector.
  
  Fig 3: Identifying Claw & Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 6 screws and No. 1 radio bracket.
  
  Fig 4: Identifying No. 1 Radio Bracket Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 RADIO BRACKET
1. Remove the 6 screws and No. 2 radio bracket.
  
  Fig 5: Identifying No. 2 Radio Bracket Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NAVIGATION RECEIVER ASSEMBLY