LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Highlander Base, FWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System (2GR-FE) (Except Hybrid) >> Engine Switch >> Removal

Engine Switch: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag deployment and seat belt pretensioner activation.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Key System)  (See REMOVAL )
  3. REMOVE HEATER CONTROL AND ACCESSORY ASSEMBLY (for Manual Air Conditioning System)  (See REMOVAL )
  4. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)  (See REMOVAL )
  5. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH  (See REMOVAL )
  7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)  (See REMOVAL )
  8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System)  (See REMOVAL )
  9. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE NO. 2 CONSOLE BOX DUCT (w/o Rear Air Conditioning System)  (See REMOVAL )
  11. REMOVE LOWER REAR CONSOLE BOX  (See REMOVAL )
  12. REMOVE CONSOLE BOX ASSEMBLY (w/o Rear Air Conditioning System)  (See REMOVAL )
  13. REMOVE CONSOLE BOX ASSEMBLY (w/ Rear Air Conditioning System)  (See REMOVAL )
  14. REMOVE FRONT NO. 1 CONSOLE BOX INSERT  (See REMOVAL )
  15. REMOVE ENGINE SWITCH 
    1. Disconnect the switch connector.
    2. Disengage the 2 claws and remove the switch.
      Fig 1: Identifying Engine Switch Connector & Claws
      G05415404Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals