LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Automatic Transmission - U340E) >> Transmission Control Cable Assembly >> Removal

Transmission Control Cable Assembly: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL (for Sedan)  (See REMOVAL )
  2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan)  (See REMOVAL )
  3. REMOVE REAR CONSOLE BOX COVER (for Hatchback)  (See REMOVAL )
  4. REMOVE REAR UPPER CONSOLE PANEL SUBASSEMBLY (for Sedan)  (See REMOVAL )
  5. REMOVE CONSOLE BOX CARPET  (See REMOVAL )
  6. REMOVE REAR CONSOLE BOX ASSEMBLY  (See REMOVAL )
  7. REMOVE BATTERY  (See REMOVAL )
  8. REMOVE BATTERY TRAY 
  9. REMOVE AIR CLEANER ASSEMBLY  (See REMOVAL )
  10. REMOVE AIR CLEANER BRACKET  (See REMOVAL )
  11. SEPARATE OXYGEN SENSOR CONNECTOR 
    1. Pull back the floor carpet and disconnect the oxygen sensor connector.
      2. Fig 1: Identifying Oxygen Sensor Connector
      G04831141Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the grommet and put the oxygen sensor connector outside of the vehicle.
  12. REMOVE FRONT EXHAUST PIPE ASSEMBLY  (See REMOVAL )
  13. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR 
    1. Remove the 2 bolts and the nut and remove floor heat insulator.
      Fig 2: Identifying Bolts, Nut And Floor Heat Insulator
      G04831142Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Disconnect the control cable from the shift lever.
      Fig 3: Identifying Control Cable
      G04831143Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Turn the nut and separate the control cable from the shift lever retainer.
      Fig 4: Identifying Nut
      G04831144Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the control cable from the control cable support.
      Fig 5: Identifying Control Cable Support
      G04831145Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the nut and disconnect the control cable from the control shaft lever.
      5. Fig 6: Identifying Nut And Control Cable
      G04831146Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the clip and separate the control cable from the control cable bracket.
    6. Remove the 3 nuts and remove the control cable.
      Fig 7: Identifying Nuts And Control Cable
      G04831147Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals