LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Seat Belt) >> REAR CENTER SEAT OUTER BELT ASSEMBLY (for Hatchback 3 Door) >> Installation

REAR CENTER SEAT OUTER BELT ASSEMBLY (for Hatchback 3 Door): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Always use "Torx" socket wrench E10 when installing the rear seat.
  1. INSTALL REAR SEAT SHOULDER BELT COVER (See INSTALLATION  )
  2. INSTALL ROOF HEADLINING ASSEMBLY (See INSTALLATION  )
  3. INSTALL SEAT BELT ANCHOR COVER (See INSTALLATION  )
  4. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY (See INSTALLATION  )
  5. INSTALL ROOF SIDE INNER GARNISH RH 
    1. w/Curtain Shield Airbag:
      1. Install a new special clip onto the roof side inner garnish.
      2. Pass the rear seat outer belt and the rear center seat outer belt through the slit in the roof side inner garnish.
      3. Engage the 4 clips and the claw and install the roof side inner garnish.
        Fig 1: Identifying Roof Side Inner Garnish RH Clips And Claws - W/O Curtain Shield Airbag
        G04835602Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. w/o Curtain Shield Airbag:
      1. Pass the rear seat outer belt and the rear center seat outer belt through the slit in the roof side inner garnish.
      2. Engage the 4 clips and the claw and install the roof side inner garnish.
        Fig 2: Identifying Roof Side Inner Garnish LH Clips And Claws - W/ Curtain Shield Airbag
        G04835603Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Engage the 4 claws and install the center belt guide.
  6. INSTALL ROOF SIDE INNER GARNISH LH  (See INSTALLATION )
  7. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH  (See INSTALLATION )
  8. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH  (See INSTALLATION )
  9. INSTALL REAR SEAT OUTER BELT ASSEMBLY RH  (See INSTALLATION )
    Fig 3: Locating Anchor Bolt
    G04835561Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. INSTALL REAR SEAT OUTER BELT ASSEMBLY LH  (See INSTALLATION )
  11. INSTALL REAR DECK TRIM COVER  (See INSTALLATION )
  12. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH  (See INSTALLATION )
  13. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH (See  INSTALLATION  ) 
  14. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH (See INSTALLATION  )
  15. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    HINT:

    Use the same procedure as for the RH side.

  16. INSTALL FRONT DOOR SCUFF PLATE RH  (See INSTALLATION )
  17. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  18. INSTALL REAR SEAT ASSEMBLY LH (for 60/40 Split Seat Type)  (See INSTALLATION )
  19. INSTALL REAR SEAT ASSEMBLY RH (for 60/40 Split Seat Type)  INSTALLATION 
  20. INSTALL NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type)  (See INSTALLATION )
  21. INSTALL NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type) 
    1. for RH Side:
      1. Install the No. 1 rear seat leg cover INSTALLATION .
    2. for LH Side:
      1. Install the No. 1 rear seat leg cover (See INSTALLATION ).
  22. INSTALL REAR SEATBACK ASSEMBLY (for Hold Down Seat Type)  INSTALLATION 
  23. INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type)  INSTALLATION 
  24. INSTALL DECK FLOOR BOX RH  (See INSTALLATION )
  25. INSTALL DECK FLOOR BOX LH  (See INSTALLATION )
  26. INSTALL DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  27. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY  (See INSTALLATION )
  28. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

scientia non olet · About LEMON Manuals