FRONT PASSENGER SEAT BELT WARNING LIGHT (for Sedan): Removal
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL (See REMOVAL )
- REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See REMOVAL )
- REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See REMOVAL )
- REMOVE INSTRUMENT CLUSTER FINISH PANEL (See REMOVAL )
- REMOVE RADIO RECEIVER ASSEMBLY (for Integrated with Panel) REMOVAL
- REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY (except Integrated with Panel) (See REMOVAL )
- REMOVE INSTRUMENT PANEL CENTER REGISTER ASSEMBLY (See REMOVAL )
- REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (Built in Front Passenger Seat Belt Warning Light)
- Disengage the 3 claws and remove the hazard warning signal switch.