LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (Lighting System) >> HAZARD WARNING SWITCH (for Sedan) >> Removal

HAZARD WARNING SWITCH (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE INSTRUMENT CLUSTER FINISH PANEL  (See REMOVAL )
  3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER  (See REMOVAL )
  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  (See REMOVAL )
  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  (See REMOVAL )
  6. REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY (w/o Radio Receiver)  (See REMOVAL )
  7. REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)  REMOVAL 
  8. REMOVE INSTRUMENT PANEL CENTER REGISTER 
    1. Disengage the 8 claws and remove the instrument panel center register.
      Fig 1: Identifying Instrument Panel Center Register Claws
      G04832944Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE HAZARD WARNING SIGNAL SWITCH 
    1. Disengage the 3 claws and remove the hazard warning signal switch.
      Fig 2: Identifying Hazard Warning Signal Switch Claws
      G04832945Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals