RADIO RECEIVER (for Sedan): Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL (See REMOVAL )
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See REMOVAL )
REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See REMOVAL )
REMOVE INSTRUMENT CLUSTER FINISH PANEL (See REMOVAL )
REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY (except Integrated with Panel) (See REMOVAL )
REMOVE RADIO RECEIVER ASSEMBLY
1. for Integrated with Panel:
  1. Disconnect the hazard warning signal switch connector.
  2. Remove the 4 bolts.
    
    Fig 1: Locating Hazard Warning Signal Switch Connector
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. Disengage the 4 clips and the 4 claws and remove the radio receiver.
    
    Fig 2: Identifying Radio Receiver Clips And Claws
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. Disconnect the plug.
  5. Disconnect the 3 radio connectors.
    
    Fig 3: Locating Radio Connectors
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. except Integrated with Panel:
  1. Remove the 4 bolts and the radio receiver.
    
    Fig 4: Locating Radio Receiver Bolts
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Disconnect the plug.
  3. Disconnect the 2 radio connectors.