FRONT PASSENGER SEAT BELT WARNING LIGHT (for Sedan): Installation
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY (Built in Front Passenger Seat Belt Warning Light)
- Engage the 3 claws and install the hazard warning signal switch.
- INSTALL INSTRUMENT PANEL CENTER REGISTER ASSEMBLY (See INSTALLATION )
- INSTALL RADIO RECEIVER ASSEMBLY (for Integrated with Panel) INSTALLATION
- INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY (except Integrated with Panel) (See INSTALLATION )
- INSTALL INSTRUMENT CLUSTER FINISH PANEL (See INSTALLATION )
- INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See INSTALLATION )
- INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See INSTALLATION )
- INSTALL INSTRUMENT PANEL LOWER CENTER FINISH PANEL (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)