Heated Oxygen Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL HEATED OXYGEN SENSOR
1. Using SST, install the sensor onto the front exhaust pipe.
  SST 09224-00010
  
  Torque: 44 N*m (449 kgf*cm, 32 ft.*lbf) (without SST)
  
  Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) (with SST)
  
  Fig 1: Identifying Heated Oxygen Sensor No. 2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
2. Pass the sensor connector through the floor panel and install the grommet.
3. Connect the sensor connector.
INSTALL INSTRUMENT PAD LOWER LH (for Sedan) (See INSTALLATION )
INSTALL REAR CONSOLE BOX ASSEMBLY (See INSTALLATION )
INSTALL CONSOLE BOX CARPET (See INSTALLATION )
INSTALL CONSOLE BOX REAR COVER (for Hatchback) (See INSTALLATION )
INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Sedan) (See INSTALLATION )
INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Hatchback Manual Transaxle) (See INSTALLATION )
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
INSTALL INSTRUMENT PANEL FINISH PANEL END LH (for Sedan) (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER (for Sedan) (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
CHECK FOR EXHAUST GAS LEAKAGE