Parking Brake System: Adjustment
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE REAR WHEEL
- ADJUST REAR DRUM BRAKE SHOE CLEARANCE (See INSTALLATION )
- INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
- INSPECT PARKING BRAKE LEVER TRAVEL
- Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.
Parking brake lever travel: 6 to 9 clicks at 200 N (20 kgf, 45 lbf)
- Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.
- REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL (for Sedan) (See REMOVAL )
- REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
- REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Hatchback Manual Transaxle) (See REMOVAL )
- REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) (See REMOVAL )
- REMOVE REAR CONSOLE BOX COVER (for Hatchback) (See REMOVAL )
- REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) (See REMOVAL )
- REMOVE CONSOLE BOX CARPET (See REMOVAL )
- REMOVE REAR CONSOLE BOX ASSEMBLY (See INSTALLATION )
- ADJUST PARKING BRAKE LEVER TRAVEL
- Loosen the lock nut and turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.
Parking brake lever travel: 6 to 9 clicks at 200 N (20 kgf, 45 lbf)
- Tighten the lock nut.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
- Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
- Check whether the parking brake drags or not.
- When operating the parking brake lever, check that the brake warning light illuminates.
Standard: Brake warning light always illuminates at the first click.
- Loosen the lock nut and turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.
- INSTALL REAR CONSOLE BOX ASSEMBLY (See INSTALLATION )
- INSTALL CONSOLE BOX CARPET (See INSTALLATION )
- INSTALL REAR CONSOLE BOX COVER (for Hatchback) (See INSTALLATION )
- INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) (See INSTALLATION )
- INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Hatchback Manual Transaxle) (See INSTALLATION )
- INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) (See INSTALLATION )
- INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)
- INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL (for Sedan) (See INSTALLATION )