Rear Brake Shoe, Wheel Cylinder & Brake Drum: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
ADJUST REAR DRUM BRAKE SHOE CLEARANCE
1. Provisionally install the 2 hub nuts.
2. Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.
3. Using a screwdriver, release the adjuster 12 notches.
4. Install the hole plug.
  
  Fig 1: Adjusting Rear Drum Brake Shoe Clearance
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FILL RESERVOIR WITH BRAKE FLUID (See BLEEDING )
BLEED MASTER CYLINDER (See BLEEDING )
BLEED BRAKE LINE (See BLEEDING )
CHECK FLUID LEVEL IN RESERVOIR (See BLEEDING )
CHECK FOR BRAKE FLUID LEAKAGE
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
INSPECT PARKING BRAKE LEVER TRAVEL (See ADJUSTMENT )
ADJUST PARKING BRAKE LEVER TRAVEL (See ADJUSTMENT )