AMPLIFIER ANTENNA (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL AMPLIFIER ANTENNA ASSEMBLY
1. Insert the hook into the body hole and install the amplifier antenna with the bolt.
2. Engage the clamp.
3. Connect the 2 amplifier antenna connectors.
4. Connect the antenna cord connector.
  
  Fig 1: Locating Amplifier Antenna Bolt And Amplifier Antenna Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL ROOF SIDE INNER GARNISH (See INSTALLATION )
INSTALL REAR SEAT SIDE COVER (See INSTALLATION )
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP (See INSTALLATION )
INSTALL REAR DOOR SCUFF PLATE (See INSTALLATION )
INSTALL LUGGAGE COMPARTMENT TRIM INNER PAD (for 60/40 Split Seat Type) (See INSTALLATION )
INSTALL SPARE WHEEL COVER ASSEMBLY (for 60/ 40 Split Seat Type) (See INSTALLATION )
INSTALL LUGGAGE COMPARTMENT FLOOR MAT (for 60/40 Split Seat Type) (See INSTALLATION )
INSTALL REAR SEATBACK ASSEMBLY
1. for 60/40 Split Seat Type:
  1. Install the rear seatback assembly INSTALLATION .
2. for Fixed Seat Type:
  1. Install the rear seatback assembly INSTALLATION .
INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY
1. for 60/40 Split Seat Type:
  1. Install the rear seat cushion cover pad sub-assembly (See INSTALLATION ).
2. for Fixed Seat Type:
  1. Install the rear seat cushion cover pad sub-assembly INSTALLATION .
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)