LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Audio System & Visual System) >> AMPLIFIER ANTENNA (for Hatchback 3 Door) >> Installation

AMPLIFIER ANTENNA (for Hatchback 3 Door): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing PRECAUTION .
NOTE: Always use "Torx" socket wrench E10 when installing the rear seat.
  1. INSTALL AMPLIFIER ANTENNA ASSEMBLY (See INSTALLATION  )
  2. INSTALL ROOF ANTENNA POLE SUB-ASSEMBLY (See INSTALLATION  )
  3. INSTALL ROOF HEADLINING ASSEMBLY (See INSTALLATION  )
  4. INSTALL FRONT PILLAR GARNISH RH  (See INSTALLATION )
  5. INSTALL FRONT PILLAR GARNISH LH  (See INSTALLATION )
  6. INSTALL MAP LIGHT ASSEMBLY  (See INSTALLATION )
  7. INSTALL ROOM LIGHT ASSEMBLY  (See INSTALLATION )
  8. INSTALL VISOR HOLDER RH  (See INSTALLATION )
  9. INSTALL VISOR HOLDER LH  (See INSTALLATION )
  10. INSTALL VISOR ASSEMBLY RH  (See INSTALLATION )
  11. INSTALL VISOR ASSEMBLY LH  (See INSTALLATION )
  12. INSTALL ASSIST GRIP SUB-ASSEMBLY  (See INSTALLATION )
  13. INSTALL ASSIST GRIP COVER  (See INSTALLATION )
  14. INSTALL ROOF HEADLINING SERVICE HOLE COVER (w/o Curtain Shield Airbag)  (See INSTALLATION )
  15. INSTALL SEAT BELT ANCHOR COVER  (See INSTALLATION )
  16. INSTALL REAR ROOF SIDE RAIL GARNISH RH  (See INSTALLATION )
  17. INSTALL REAR ROOF SIDE RAIL GARNISH LH  (See INSTALLATION )
  18. INSTALL ROOF SIDE INNER GARNISH RH  (See INSTALLATION )
  19. INSTALL ROOF SIDE INNER GARNISH LH  (See INSTALLATION )
  20. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY  (See INSTALLATION )
  21. INSTALL CENTER PILLAR UPPER GARNISH RH  (See INSTALLATION )
  22. INSTALL CENTER PILLAR UPPER GARNISH LH  (See INSTALLATION )
  23. INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH  (See INSTALLATION )
  24. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH  (See INSTALLATION )
  25. INSTALL SEAT BELT ANCHOR COVER CAP  (See INSTALLATION )
  26. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH  (See INSTALLATION )
  27. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH  (See INSTALLATION )
  28. INSTALL REAR SEAT OUTER BELT ASSEMBLY RH  (See INSTALLATION )
  29. INSTALL REAR SEAT OUTER BELT ASSEMBLY LH  (See INSTALLATION )
  30. INSTALL REAR DECK TRIM COVER  (See INSTALLATION )
  31. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH  (See INSTALLATION )
  32. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH  (See INSTALLATION )
  33. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH  (See INSTALLATION )
  34. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH  (See INSTALLATION )
  35. INSTALL COWL SIDE TRIM BOARD RH  (See INSTALLATION )
  36. INSTALL COWL SIDE TRIM BOARD LH  (See INSTALLATION )
  37. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY RH  (See INSTALLATION )
  38. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY LH  (See INSTALLATION )
  39. INSTALL FRONT DOOR SCUFF PLATE RH  (See INSTALLATION )
  40. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  41. INSTALL REAR SEAT ASSEMBLY RH (for 60/40 Slide Reclining Hold Down Seat Type)  INSTALLATION 
  42. INSTALL REAR SEAT ASSEMBLY LH (for 60/40 Split Seat Type)  (See INSTALLATION )
  43. INSTALL NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type)  (See INSTALLATION )
  44. INSTALL NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type) 
    1. for RH Side:
      1. Install the No. 1 rear seat leg cover INSTALLATION .
    2. for LH Side:
      1. Install the No. 1 rear seat leg cover (See INSTALLATION ).
  45. INSTALL REAR SEATBACK ASSEMBLY (for Hold Down Seat Type)  INSTALLATION 
  46. INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type)  INSTALLATION 
  47. INSTALL DECK FLOOR BOX RH  (See INSTALLATION )
  48. INSTALL DECK FLOOR BOX LH  (See INSTALLATION )
  49. INSTALL DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  50. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY  (See INSTALLATION )
  51. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)