LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Audio System & Visual System) >> AMPLIFIER ANTENNA (for Hatchback 5 Door) >> Installation

AMPLIFIER ANTENNA (for Hatchback 5 Door): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing PRECAUTION .
NOTE: Always use "Tone" socket wrench E10 when installing the rear seat.
  1. INSTALL AMPLIFIER ANTENNA ASSEMBLY 
    1. Set the amplifier antenna into the hole in the roof, and place the amplifier antenna cord in the cutout of the amplifier antenna.
    2. Install the amplifier antenna with the antenna nut.

      Torque: 4.5 N*m (46 kgf*cm, 40 in.*lbf) 

      Fig 1: Locating Amplifier Antenna Nut
      G04833628Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Engage the 5 clamps.
      4. Fig 2: Identifying Clamps
      G04833629Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ROOF ANTENNA POLE SUB-ASSEMBLY (See INSTALLATION  )
  3. INSTALL ROOF HEADLINING ASSEMBLY (See INSTALLATION  )
  4. INSTALL FRONT PILLAR GARNISH RH  (See INSTALLATION )
  5. INSTALL FRONT PILLAR GARNISH LH  (See INSTALLATION )
  6. INSTALL MAP LIGHT ASSEMBLY  (See INSTALLATION )
  7. INSTALL ROOM LIGHT ASSEMBLY  (See INSTALLATION )
  8. INSTALL VISOR HOLDER RH  (See INSTALLATION )
  9. INSTALL VISOR HOLDER LH  (See INSTALLATION )
  10. INSTALL VISOR ASSEMBLY RH  (See INSTALLATION )
  11. INSTALL VISOR ASSEMBLY LH  (See INSTALLATION )
  12. INSTALL ROOF HEADLINING SERVICE HOLE COVER (w/o Curtain Shield Airbag)  (See INSTALLATION )
  13. INSTALL ASSIST GRIP SUB-ASSEMBLY  (See INSTALLATION )
  14. INSTALL ASSIST GRIP COVER  (See INSTALLATION )
  15. INSTALL SEAT BELT ANCHOR COVER  (See INSTALLATION )
  16. INSTALL CENTER PILLAR UPPER GARNISH RH  (See INSTALLATION )
  17. INSTALL CENTER PILLAR UPPER GARNISH LH  (See INSTALLATION )
  18. INSTALL CENTER PILLAR LOWER GARNISH RH  (See INSTALLATION )
  19. INSTALL CENTER PILLAR LOWER GARNISH LH  (See INSTALLATION )
  20. INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH  (See INSTALLATION )
  21. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH  (See INSTALLATION )
  22. INSTALL SEAT BELT ANCHOR COVER CAP  (See INSTALLATION )
  23. INSTALL ROOF SIDE INNER GARNISH RH  (See INSTALLATION )
  24. INSTALL ROOF SIDE INNER GARNISH LH  (See INSTALLATION )
  25. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY  (See INSTALLATION )
  26. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH  (See INSTALLATION )
  27. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH  (See INSTALLATION )
  28. INSTALL REAR SEAT OUTER BELT ASSEMBLY RH  (See INSTALLATION )
  29. INSTALL REAR SEAT OUTER BELT ASSEMBLY LH  (See INSTALLATION )
  30. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH  (See INSTALLATION )
  31. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH  (See INSTALLATION )
  32. INSTALL REAR DOOR SCUFF PLATE RH  (See INSTALLATION )
  33. INSTALL REAR DOOR SCUFF PLATE LH  (See INSTALLATION )
  34. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH  (See INSTALLATION )
  35. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH  (See INSTALLATION )
  36. INSTALL COWL SIDE TRIM BOARD RH  (See INSTALLATION )
  37. INSTALL COWL SIDE TRIM BOARD LH  (See INSTALLATION )
  38. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY RH  (See INSTALLATION )
  39. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY LH  (See INSTALLATION )
  40. INSTALL FRONT DOOR SCUFF PLATE RH  (See INSTALLATION )
  41. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  42. INSTALL REAR DECK TRIM COVER  (See INSTALLATION )
  43. INSTALL REAR SEAT ASSEMBLY RH (for 60/40 Split Seat Type)  INSTALLATION 
  44. INSTALL REAR SEAT ASSEMBLY LH (for 60/40 Split Seat Type)  (See INSTALLATION )
  45. INSTALL NO. 2 REAR SEAT LEG COVER (for 60/40 Split Seat Type)  (See INSTALLATION )
  46. INSTALL NO. 1 REAR SEAT LEG COVER (for 60/40 Split Seat Type) 
    1. for RH Side:
      1. Remove the No. 1 rear seat leg cover INSTALLATION .
    2. for LH Side:
      1. Remove the No. 1 rear seat leg cover (See INSTALLATION ).
  47. INSTALL REAR SEATBACK ASSEMBLY (for Hold Down Seat Type)  INSTALLATION 
  48. INSTALL REAR SEAT CUSHION COVER PAD SUB-ASSEMBLY (for Hold Down Seat Type)  INSTALLATION 
  49. INSTALL DECK FLOOR BOX RH  (See INSTALLATION )
  50. INSTALL DECK FLOOR BOX LH  (See INSTALLATION )
  51. INSTALL DECK BOARD SUB-ASSEMBLY  (See INSTALLATION )
  52. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY  (See INSTALLATION )
  53. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

scientia non olet · About LEMON Manuals