FRONT PASSENGER AIRBAG ASSEMBLY (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See AIRBAG SYSTEM ).

Fig 1: Removing Locking Button

REMOVE INSTRUMENT PANEL WIRE ASSEMBLY
1. Connect the 2 airbag connectors to install the instrument panel wire.
  NOTE: Lock the locking button securely.
  
  Fig 2: Installing Locking Button
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT PASSENGER AIRBAG ASSEMBLY (w/ Front Passenger Airbag)
1. Engage the 10 hooks so that the connector side faces the outside of the vehicle and install the instrument panel passenger airbag.
2. Install the wire harness onto the 2 claws of the instrument panel.
INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY (See INSTALLATION )
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (See INSTALLATION )
INSTALL FRONT PILLAR GARNISH RH (See INSTALLATION )
INSTALL FRONT PILLAR GARNISH LH (See INSTALLATION )

Fig 3: Identifying Instrument Panel Passenger Airbag And Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH (See INSTALLATION )
INSTALL COMBINATION METER ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT CLUSTER FINISH PANEL (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
CHECK SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )