HAZARD WARNING SWITCH (for Sedan): Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL HAZARD WARNING SIGNAL SWITCH
1. Engage the 3 claws and remove the hazard warning signal switch.
  
  Fig 1: Identifying Hazard Warning Signal Switch Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL CENTER REGISTER
1. Engage the 8 claws and the instrument panel center register.
INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY (w/o Radio Receiver) (See INSTALLATION )
REMOVE RADIO RECEIVER ASSEMBLY (w/ Radio Receiver) (See REASSEMBLY )
INSTALL INSTRUMENT CLUSTER FINISH PANEL (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL END RH (See INSTALLATION )
INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

Fig 2: Identifying Instrument Panel Center Register Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002