RADIO RECEIVER (for Sedan): Reassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL RADIO BRACKET RH
1. for Integrated with Panel:
  1. Align the 6 bosses of the radio bracket with the hole in the radio receiver and install the radio bracket with the 2 screws.
    
    Fig 1: Locating Radio Bracket Screws (For Integrated With Panel)
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. except Integrated with Panel:
  1. Align the 6 bosses of the radio bracket with the hole in the radio receiver and install the radio bracket with the 4 screws.
REMOVE RADIO BRACKET LH
HINT:

Use the same procedure as for the RH side.
INSTALL INSTRUMENT PANEL CENTER REGISTER ASSEMBLY (for Integrated with Panel) (See INSTALLATION )

Fig 2: Locating Radio Bracket Screws (Except Integrated With Panel)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002