Front Door Lock: Removal

HINT:

• Use the same procedure for both the RH and LH sides.
• The procedure described below is for the RH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
2. REMOVE FRONT ARMREST BASE UPPER PANEL  (See DISASSEMBLY )
3. REMOVE FRONT DOOR TRIM BOARD SUBASSEMBLY  (See DISASSEMBLY )
4. REMOVE FRONT NO. 2 DOOR SERVICE HOLE COVER  (See DISASSEMBLY )
5. REMOVE OUTER REAR VIEW MIRROR  (See REMOVAL )
6. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY  (See REMOVAL )
7. REMOVE FRONT NO. 1 SPEAKER  (See REMOVAL )
8. REMOVE FRONT DOOR SERVICE HOLE COVER  (See DISASSEMBLY )
9. REMOVE FRONT DOOR INSIDE PANEL PLATE  (See DISASSEMBLY )
10. REMOVE FRONT DOOR CHECK ASSEMBLY  (See DISASSEMBLY )
11. REMOVE FRONT DOOR WEATHERSTRIP  (See DISASSEMBLY )
12. REMOVE FRONT DOOR GLASS RUN  (See DISASSEMBLY )
13. REMOVE FRONT DOOR FRAME SUB-ASSEMBLY FRONT LOWER  (See DISASSEMBLY )
14. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH  (See DISASSEMBLY )
15. REMOVE FRONT DOOR WINDOW FRAME REAR LOWER  (See DISASSEMBLY )
16. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY  (See DISASSEMBLY )
17. REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY 
    1. Remove the hole plug.
    2. Using a "Torx" socket wrench T30, loosen the screw and remove the front door lock cylinder.
       Fig 1: Identifying Front Door Lock Cylinder Screw

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
18. REMOVE FRONT DOOR LOCK 
    1. Using "Torx" socket wrench T30, loosen the 3 screws.
    Fig 2: Identifying Front Door Lock Screws
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Move the front door lock downward, remove the outside handle frame link and remove the front door lock.
    3. Disengage the 5 claws and open the cover.
       Fig 3: Identifying Claws

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the front door lock remote control cable and the front door inside locking cable.
    Fig 4: Identifying Front Door Lock Remote Control Cable And Front Door Inside Locking Cable
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the door lock wire harness seal.