Front Door Glass Weatherstrip: Removal

HINT:

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
2. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL 

   HINT:

   Use the same procedure as for the RH side (See DISASSEMBLY ).

3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY 

   HINT:

   Use the same procedure as for the RH side (See DISASSEMBLY ).

4. REMOVE FRONT DOOR NO. 2 SERVICE HOLE COVER 

   HINT:

   Use the same procedure as for the RH side (See DISASSEMBLY ).

5. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY 
   1. for Driver Side:
      1. Provisionally install the power window regulator master switch.
   2. for Front Passenger Side:
      1. Provisionally install the power window regulator switch.
   3. Close the door glass.
   4. Disconnect the connector.
   5. Remove the 3 bolts and the outer rear view mirror.
      NOTE: Do not drop or damage the outer rear view mirror when removing the bolts.
      Fig 1: Identifying Outer Rear View Mirror Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY 
   1. Apply protective tape to the front door panel in the area around the front door glass outer weatherstrip.
      Fig 2: Identifying Front Door Panel Protective Tape

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Using a molding remover, disengage the 8 claws and remove the front door glass outer weatherstrip.
      Fig 3: Removing Front Door Glass Outer Weatherstrip

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002