Outer Rear View Mirror: Removal
HINT:
- Use the same procedure for both the RH and LH sides.
- The procedure described below is for the LH side.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE FRONT ARMREST BASE UPPER PANEL (See REMOVAL )
- REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
HINT:
Use the same procedure as for the RH side (See DISASSEMBLY ).
- REMOVE NO. 2 FRONT DOOR SERVICE HOLE COVER
HINT:
Use the same procedure as for the RH side (See DISASSEMBLY ).
- REMOVE OUTER REAR VIEW MIRROR
- Driver side:
Provisionally install the power window regulator master switch.
- Passenger side:
Provisionally install the power window regulator switch.
- Close the door glass.
- Disconnect the connector.
- Remove the 3 bolts and the outer rear view mirror.NOTE: Do not drop or damage the outer rear view mirror when removing the bolts.
- Apply protective tape to the lower part of the mirror body.
- Press down the upper part of the mirror and tilt the mirror.
- Using a screwdriver with its tip wrapped in protective tape, insert it between the mirror holder and the mirror holder base.
- Twist and disengage the 2 clips on the lower side of the mirror.
HINT:
Heating the mirror holder with a domestic dryer before this procedure makes the work easier.
- While holding the mirror with the screwdriver, disengage the 4 clips and 2 claws on the upper side of the mirror and remove the mirror.
- Driver side:
Remove the power window regulator master switch.
- Passenger side:
Remove the power window regulator switch.
- Driver side:
- REMOVE OUTER REAR VIEW MIRROR ILLUMINATION LIGHT BULB (w/ Illumination)
- Turn the outer rear view mirror illumination light socket and bulb, in the direction indicated by the allow in Fig 5, to remove them.
- Remove the outer rear view mirror illumination light bulb from the light socket.