LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 67 (Engine Control System (2GR-FE Except Hybrid) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection And Installation) >> Knock Sensor >> Removal

Knock Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCHARGE FUEL SYSTEM PRESSURE  (See REMOVAL )
  2. REMOVE ENGINE UNDER COVER LH 
  3. REMOVE ENGINE UNDER COVER RH 
  4. DRAIN ENGINE COOLANT  (See ON-VEHICLE INSPECTION )
  5. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH  (See REMOVAL )
  6. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH  (See REMOVAL )
  7. REMOVE FRONT FENDER TO COWL SIDE SEAL LH  (See REMOVAL )
  8. REMOVE FRONT FENDER TO COWL SIDE SEAL RH  (See REMOVAL )
  9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE WINDSHIELD WIPER MOTOR AND LINK  (SeeREMOVAL )
  11. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY (See  REMOVAL   ) 
  12. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL   ) 
  13. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  14. REMOVE AIR CLEANER INLET ASSEMBLY  (See REMOVAL )
  15. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (See  REMOVAL   ) 
  16. REMOVE AIR CLEANER CASE SUB-ASSEMBLY  (See REMOVAL )
  17. REMOVE NO. 1 AIR CLEANER INLET  (See REMOVAL )
  18. REMOVE INTAKE AIR SURGE TANK  (See REMOVAL )
  19. SEPARATE FUEL TUBE SUB-ASSEMBLY  (See REMOVAL )
  20. REMOVE INTAKE MANIFOLD  (See REMOVAL )
  21. REMOVE KNOCK CONTROL SENSOR 
    1. Disconnect the 2 knock control sensor connectors.
    2. Remove the 2 bolts and 2 knock control sensors.
      Fig 1: Locating Knock Control Sensor Connectors And Bolts
      G04973904Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals