Differential Oil Seal: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL FRONT TRANSAXLE CASE COVER OIL SEAL
1. Coat a new oil seal lip with MP grease.
2. Using SST and a hammer, install the oil seal.
  SST 09608-10010, 09950-70010 (09951 -07200)
  
  Installation depth: -0.5 to 0.5 mm (-0.020 to 0.020 in.)
  
  NOTE: Be careful not to damage the oil seal lip.
  
  Fig 1: Taping In Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSAXLE CASE OIL SEAL
1. Coat a new oil seal lip with MP grease.
2. Using SST and a hammer, install the oil seal.
SST 09608-32010, 09950-70010 (09951-07200)

Installation depth: 3.0 to 4.0 mm (0.1181 to 0.1575 in.)

NOTE: Be careful not to damage the oil seal lip.

Fig 2: Installing Oil Seal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
TMC made: (See INSTALLATION ).

TMMK made: (See INSTALLATION ).
INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
HINT:

Use the same procedures described for the LH side.
INSTALL FRONT WHEELS
Torque: 103 N*m (1, 050 kgf*cm, 76 ft.*lbf)
ADD MANUAL TRANSAXLE OIL
1. Park the vehicle on a level place.
2. Remove the filler plug and gasket.
3. Check that the oil surface is within 5 mm (0.20 in.) below the lowest point of the filler plug opening.
  Oil grade: API GL-4 or GL-5
  
  Viscosity: SAE 75W-90
  
  Fig 3: Checking Oil Surface
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Problems may occur if the oil level is too high or too low.
  - After replacing the oil, drive the vehicle and check the oil level again.
4. Check for oil leakage if the oil level is low.
5. Install the filler plug and a new gasket.
  Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
INSPECT MANUAL TRANSAXLE OIL (See ON-VEHICLE INSPECTION )
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
See ADJUSTMENT .
CHECK ABS SPEED SENSOR SIGNAL
1. ABS: See TEST MODE PROCEDURE
2. VSC (for BOSCH): See TEST MODE PROCEDURE
3. VSC (for ADVICS): See TEST MODE PROCEDURE