LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft >> FRONT DRIVE SHAFT (for TMMK Made) >> Installation

FRONT DRIVE SHAFT (for TMMK Made): Installation

  1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH  (See INSTALLATION )
  2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH  (See INSTALLATION )
  3. INSTALL FRONT AXLE ASSEMBLY  (See INSTALLATION )
  4. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM  (See INSTALLATION )
  5. INSTALL TIE ROD END SUB-ASSEMBLY  (See INSTALLATION )
  6. INSTALL FRONT SPEED SENSOR  (See INSTALLATION )
  7. INSTALL FRONT STABILIZER LINK ASSEMBLY  (See INSTALLATION )
  8. INSTALL FRONT AXLE HUB NUT  (See INSTALLATION )
  9. INSTALL FRONT WHEEL 

    Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

  10. ADD AUTOMATIC TRANSAXLE FLUID (for Automatic Transaxle) 
    1. for 2GR-FE: See ADJUSTMENT
    2. for 2AZ-FE: See INSTALLATION
  11. ADD MANUAL TRANSAXLE OIL (for Manual Transaxle)  (See INSTALLATION )
  12. INSPECT AUTOMATIC TRANSAXLE FLUID (for 2AZ-FE Automatic Transaxle)  (See ON-VEHICLE INSPECTION )
  13. INSPECT MANUAL TRANSAXLE OIL (for Manual Transaxle)  (See MANUAL TRANSAXLE OIL )
  14. ADJUST FRONT WHEEL ALIGNMENT 

    HINT:

    See ADJUSTMENT

  15. CHECK ABS SPEED SENSOR SIGNAL 
    1. ABS: See TEST MODE PROCEDURE
    2. VSC (for BOSCH): See TEST MODE PROCEDURE
    3. VSC (for ADVICS): See TEST MODE PROCEDURE
scientia non olet · About LEMON Manuals