LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Camry Base, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System (Except Hybrid) >> Navigation Antenna Cord >> Removal

Navigation Antenna Cord: Removal

  1. PRECAUTION 

    See PRECAUTION

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (See PRECAUTION ).
  4. REMOVE LOWER NO. 3 STEERING WHEEL COVER  (See REMOVAL )
  5. REMOVE LOWER NO. 2 STEERING WHEEL COVER  (See REMOVAL )
  6. REMOVE STEERING PAD  (See REMOVAL )
  7. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL )
  8. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH  (See REMOVAL )
  10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMC Made)  (See REMOVAL )
  11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMMK Made)  (See REMOVAL )
  12. REMOVE STEERING COLUMN COVER (for TMC Made)  (See REMOVAL )
  13. REMOVE STEERING COLUMN COVER (for TMMK Made)  (See REMOVAL )
  14. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY  (See REMOVAL )
  15. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY  (See REMOVAL )
  16. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Key System)  (See REMOVAL )
  17. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Key System)  (See REMOVAL )
  18. REMOVE INSTRUMENT CLUSTER FINISH PANEL  (See REMOVAL )
  19. REMOVE COMBINATION METER ASSEMBLY (for TMC Made)  (See REMOVAL )
  20. REMOVE COMBINATION METER ASSEMBLY (for TMMK Made)  (See REMOVAL )
  21. REMOVE FRONT DOOR SCUFF PLATE RH  (See REMOVAL )
  22. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH 
  23. REMOVE INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  24. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMC Made)  (See REMOVAL )
  25. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMMK Made)  (See REMOVAL )
  26. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle)  (See REMOVAL )
  27. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)  (See REMOVAL )
  28. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH  (See REMOVAL )
  29. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH  (See REMOVAL )
  30. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY (for Automatic Transaxle)  (See REMOVAL )
  31. REMOVE UPPER CONSOLE PANEL (for Manual Transaxle)  (See REMOVAL )
  32. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Automatic Transaxle)  (See REMOVAL )
  33. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Manual Transaxle)  (See REMOVAL )
  34. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMC Made)  (See REMOVAL )
  35. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMMK Made)  (See REMOVAL )
  36. REMOVE INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY  (See REMOVAL )
  37. REMOVE NAVIGATION RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY (See  REMOVAL   ) 
  38. REMOVE CONSOLE BOX POCKET  (See REMOVAL )
  39. REMOVE CONSOLE BOX CARPET  (See REMOVAL )
  40. REMOVE CONSOLE BOX ASSEMBLY (for TMC Made)  (See REMOVAL )
  41. REMOVE CONSOLE BOX ASSEMBLY (for TMMK Made)  (See REMOVAL )
  42. REMOVE NO. 2 CONSOLE BOX INSERT FRONT (for TMC Made)  (See REMOVAL )
  43. REMOVE NO. 2 CONSOLE BOX INSERT FRONT (for TMMK Made)  (See REMOVAL )
  44. REMOVE NO. 1 CONSOLE BOX INSERT FRONT (for TMC Made)  (See REMOVAL )
  45. REMOVE NO. 1 CONSOLE BOX INSERT FRONT (for TMMK Made)  (See REMOVAL )
  46. REMOVE FRONT PILLAR GARNISH LH  (See REMOVAL )
  47. REMOVE INSTRUMENT PANEL NO. 1 REGISTER ASSEMBLY  (See REMOVAL )
  48. REMOVE INSTRUMENT PANEL NO. 1 SPEAKER PANEL SUB-ASSEMBLY  (See REMOVAL )
  49. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for LH Side)  (See REMOVAL )
  50. REMOVE FRONT PILLAR GARNISH RH  (See REMOVAL )
  51. REMOVE INSTRUMENT PANEL NO. 3 REGISTER ASSEMBLY  (See REMOVAL )
  52. REMOVE INSTRUMENT PANEL NO. 2 SPEAKER PANEL SUB-ASSEMBLY  (See REMOVAL )
  53. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for RH Side) 

    HINT:

    Use the same procedures for the RH side and the LH side (See REMOVAL ).

  54. REMOVE NO. 1 DEFROSTER NOZZLE GARNISH  (See REMOVAL )
  55. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMC Made)  (See REMOVAL )
  56. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMMK Made)  (See REMOVAL )
  57. REMOVE NO. 3 INSTRUMENT PANEL STAY  (See REMOVAL )
  58. REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT (for TMC Made)  (See REMOVAL )
  59. REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT (for TMMK Made)  (See REMOVAL )
  60. REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT (for TMC Made)  (See REMOVAL )
  61. REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT (for TMMK Made)  (See REMOVAL )
  62. REMOVE DEFROSTER NOZZLE ASSEMBLY (for TMC Made)  (See REMOVAL )
  63. REMOVE DEFROSTER NOZZLE ASSEMBLY (for TMMK Made)  (See REMOVAL )
  64. REMOVE NO. 1 HEATER TO REGISTER DUCT (for TMC Made)  (See REMOVAL )
  65. REMOVE NO. 1 HEATER TO REGISTER DUCT (for TMMK Made)  (See REMOVAL )
  66. REMOVE NO. 3 HEATER TO REGISTER DUCT (for TMC Made)  (See REMOVAL )
  67. REMOVE NO. 3 HEATER TO REGISTER DUCT (for TMMK Made)  (See REMOVAL )
  68. REMOVE NO. 2 HEATER TO REGISTER DUCT (for TMC Made)  (See REMOVAL )
  69. REMOVE NO. 2 HEATER TO REGISTER DUCT (for TMMK Made)  (See REMOVAL )
  70. REMOVE NAVIGATION ANTENNA ASSEMBLY 
    1. Disengage the 3 clamps.
    2. Remove the 2 screws and navigation antenna assembly.
      Fig 1: Identifying Navigation Antenna Assembly With Clamps And Screws
      G04981011Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals