| Ground short inspection |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>GROUND SHORT INSPECTION . |
Shorted to ground in the communication circuit or control module. |
| Check power supply short |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>CHECK POWER SUPPLY SHORT . |
Shorted to battery power supply in the communication circuit or control module. |
| Greater than 52 Ω and less than 62 Ω |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>GREATER THAN 52 Ω AND LESS THAN 62 Ω . |
Combined resistance of end resistance does not have malfunction; short to ground or +B short of the CAN communication circuit is possible, however. |
| 52 Ω or less |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>52 Ω OR LESS . |
Resistance is lower than combined resistance of end resistance. Short to CAN Hi and CAN Lo on the CAN communication circuit is possible. |
| 62 Ω or more |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>62 Ω OR MORE . |
Resistance is higher than combined resistance of end resistance. Open circuit of CAN communication circuit is possible. |
| Related lines, more than 52 Ω and less than 62 Ω (TCM) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (TCM) . |
No TCM data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (steering angle sensor) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (STEERING ANGLE SENSOR) . |
No steering angle sensor data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (A/C control module) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (A/C CONTROL MODULE) . |
No A/C data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (power steering) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (POWER STEERING) . |
No power steering data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (combination meter) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (COMBINATION METER) . |
No meter data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (infotainment system) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (INFOTAINMENT SYSTEM) . |
No infotainment data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (airbag) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (AIRBAG) . |
No airbag data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (keyless access system) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (KEYLESS ACCESS SYSTEM) . |
No keyless access control module data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (BSD/RCTA) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (BSD/RCTA) . |
No BSD/RCTA data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (headlight beam leveler) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (HEADLIGHT BEAM LEVELER) . |
No headlight beam leveler data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (remote engine starter) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (REMOTE ENGINE STARTER) . |
Perform inspection when the remote engine starter does not operate, while the mobile key side operates normally. |
| Related lines, more than 52 Ω and less than 62 Ω (stereo camera) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (STEREO CAMERA) . |
No stereo camera data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (immobilizer) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (IMMOBILIZER) . |
No immobilizer data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (telematics) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (TELEMATICS) . |
No telematics data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (RAB) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (RAB) . |
Perform inspection when no RAB data is received, or invalid data is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (VDC) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (VDC) . |
No VDC data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (keyless entry/TPMS) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (KEYLESS ENTRY/TPMS) . |
No keyless entry/TPMS data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (MFD) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (MFD) . |
No MFD data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (EyeSight assist monitor) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (EyeSight ASSIST MONITOR) . |
No EyeSight assist monitor data is received. Perform inspection when faulty is detected. |
| Related lines, more than 52 Ω and less than 62 Ω (rear view mirror) |
Ref. to LAN SYSTEM (DIAGNOSTICS)>CAN Communication Circuit Check>INSPECTION>RELATED LINES, MORE THAN 52 Ω AND LESS THAN 62 Ω (REAR VIEW MIRROR) . |
Perform inspection when rear view mirror malfunction is detected. |